Imperial-tools 700-F User Manual

No. 700-F TUBE BENDEROperation and Service InstructionsWith Replacement Parts List Warning! Keep body parts away from pinch/bend areas while

l. If the tension yoke (5) was disassembled for replacement of parts, place the bend indicating (dial) plate (4) on the sleeve bearing (3) and press

11123456262713141615192018212217252411121098232831324140393837424547463029444336333435Figure 12. Tube Bender Assembly

P0000007 revB©2008 Stride Tool Inc.Printed in U.S.A.Printed in U.S.A.30333 Emerald Valley Parkway • Glenwillow, Ohio 44139 USAwww.imperial-tools.com •

11121314151617181920Part Name74588745897455474555745697457274575745787458174584BLOCK (3/8 & 1/2”)BLOCK (5/8 & 3/4”)SHAFT (1/4”)SHAFT (5/16 - 3

SECTION IUSE AND MAINTENANCE1. INTRODUCTION6. DESCRIPTION AND FUNCTIONNOTETABLE 1. TUBE SIZESTube diameter(O.D. inches)Wall thickness(inches)Bend rad

Figure 2. Clamping the Tube Bender Proper in a Vise11. OPERATION.12. SETTING UP THE MACHINE. (See Figure 2.) a. Use a substantial vise with strong, f

Figure 7. Attaching the Rack to the Form ShoeNOTE g. While holding the rack in engagement with the form shoe, slide the form shoe into place alongsid

Figure 11. Forming a Bend with Tube BenderClamped in a Vise b. While the ratchet handle is being operated, the form block rolling against the form sh

must not be used, since they will not withstand the extreme contact pressures. If grease of the above specification, or an equivalent, is not availabl

InspectionINSPECTION OF INDIVIDUAL PARTS AND COMPONENTS(See figure 12 for reference numbers)NomenclatureRef. No.2347810111213141518192023,39and 432426

InspectionNomenclatureRef. No.INSPECTION OF INDIVIDUAL PARTS AND COMPONENTS (Cont)333536373840414244AllAllSleeve bearingsWormKeyCountershaft drive end